How to apply your vinyl decals

Caution: Before applying on freshly painted walls, allow 2 weeks for the paint to cure fully! If your vinyl decal is fairly large, get a friend to help you set it up!

1) White backing 2) Vinyl decal 3) Transfer tape

Vinyl decals are a new smart, elegant & exciting way to decorate interiors and change the entire look of a room in an instant. Decals are also easy to re­move without damaging surfaces. Simply follow the instructions:

Step 1 Lay on a hard, flat surface and rub firmly over the decal with a squeegee (credit card, rubber spatula...). This will strengthen the bond between the vinyl decal and the transfer tape.

Step 2 Remove the white backing, making sure the vinyl decal sticks properly to the tape.

Step 3 Arrange the vinyl decal on the desired surface. Smooth the top edge onto the surface and firmly smooth out the tape all the way down.

Step 4 Finish the application by rubbing over the entire vinyl decal with the squeegee in order to remove any air bubble and activate the bond between the vinyl graphic and the surface.

Step 5 Remove transfer tape from one corner & slowly roll along the surface. If part of the decal stick to the tape, simply roll back, repress firmly & continue peeling away again.

Step 6 Remove any air bubbles by rubbing over the decal with a clean cloth (you can also poke bubbles with a needle and then smooth it out). Rub over very firmly on textured surfaces!!

Download installation instructions